Page not found - Superchips

Flashcal for JT Gladiator - 3571-JT

Suggested retail: $287.00
Your Price: $257.95
  • **DUE TO GROWING DEMAND AND INCREASED ORDER ACTIVITY, PLEASE ALLOW FOR 1 TO 2 ADDITIONAL DAYS FOR SHIPMENTS.**

    ALL SHIPMENTS TO CANADA ARE SUBJECT TO BROKERAGE FEES. ORDERS ARE SHIPPED MONDAY-FRIDAY. ANY PRODUCT ORDERED AFTER 2:00 PM MST OR ON S

    Product Accessories

    Overview
    Product Details
    Features
    Emissions

    Now Shipping!


    It's here! The Flashcal for the 2020 Gladiator JT! Gladiator owners aren't leaving their rigs stock and Superchips is here to help with the tire and gear options Flashcal provides. Enjoy seamless functionality to accommodate the lift, suspension, and tires you've installed on your Gladiator. Superchips has loaded the Flashcal PN 3571-JT with the most sought-after features. Configure your Gladiator to review all product features. Be sure to pay close attention to your install guide. The team at Superchips spells out how to install your Flashcal to take advantage of tire size, gear ratio, TPMS adjust and more. Enjoy the ride with the Flashcal for JT Gladiator


    * Results and feature set may vary based on vehicle make, model, and aftermarket upgrades. Read all instructions before installation and/or operation of this product use.


    * This product has not been tested or validated on right-hand drive Jeep applications or imported (non-American VIN based)Jeep applications. They are not supported by this product.


    * Note: Daytime running light options are only available on Gladiators where daytime running lights come equipped.

    Key Product Features

    • Corrects speedometer for tire upgrades between 26- 40"
    • Speedometer recalibration for gear /axle swaps up to 5.38
    • Transfer case gear low: 2.72 - 5.00
    • Sway bar disconnect in 2HI (up to 25 MPH)
    • Daytime running light options
    • One touch lane change on/off
    • TPMS On/Off
    • TPMS Adjust
    • Fog light droput on/off
    • Daytime running light dropout on/off
    • Daytime running light location - high beam, low beam, turn signal, fog lights, Eurpean/fender lights, none
    • Auto park on/off* (3.6L JL only, usedas a feature while device is plugged in)
    • Reads and clears diagnostic trouble codes
    • Internet updateable


    * Results and feature set may vary based on vehicle make, model, and aftermarket upgrades. Read all instructions before installation and/or operation of this product use.


    * This product has not been tested or validated on right hand drive Jeep applications or imported (non-American VIN based)Jeep applications. They are not supported by this product.

    You must configure your vehicle to view Product Features

    This part is legal for sale or use on Emissions Controlled Vehicles, Uncontrolled (Non-Emissions Controlled) Vehicles, and Racing Use Only Vehicles because it does not affect vehicle emissions and is not covered by emissions regulations

    • bvseo_sdk, p_sdk, 3.2.1
    • CLOUD, getContent, 43.42ms
    • REVIEWS, PRODUCT
    • bvseo-msg: HTTP status code of 404 was returned;

    Is the bypass module included with the FlashCal?

    Asked by: Carlo Mojica
    Yes it is!!
    Answered by: Anthony M
    Date published: 2020-03-23

    Can it turn off the low tire pressure system if you put larger tires with out the tire pressure sensers in them?

    Asked by: lbarber
    You can use our device to turn off the low pressure warning but since the sensors are not in the tires you will still have a tpms fault in the info center
    Answered by: Anthony M
    Date published: 2020-02-07

    If you are using this to only update tire size, after the tuning is installed and the device removed, do you need to flash to stock setting prior to dealership visits? With the AEV Procal snap you aren’t’ bypassing the SGM so you don’t revert to stock.

    Asked by: Gnala
    Its always best to return the vehicle back to stock before going into the dealer so they do not write over our tuning
    Answered by: Anthony M
    Date published: 2020-01-07

    After adjusting the tire size, can I remove the security jumper and place security plugs back into the normal state or will I need to keep the jumper in place to hold the new tire size?

    Asked by: heliix
    You can remove it once the tuning is installed
    Answered by: Anthony M
    Date published: 2019-10-22

    Is there a FlashPaq download available for the Jeep Gladiator or do you utilize another model?

    Asked by: aoe3cheng
    We are still working on the engine tuning at this time. Once tuning is released you will be able to upgrade online
    Answered by: Anthony M
    Date published: 2019-10-29

    Does the Gladiator model turn off the Smart Start/Stop to leave permanently in the off position? Meaning, I don’t have to turn it off each time I start the Jeep?  

    Asked by: RSK545
    no it wont, it only tells you to unplug it under the hood...which will cause a check ESS light to come on ALL the time...you dont need to spend $240 to do that....just sayin
    Answered by: Jeepster
    Date published: 2019-07-27

    Will the JL Wrangler Flashcal work on the JT Gladiator? I'll be trading in my JL for a JT soon and it'd be nice to be able to reuse it instead of purchase a new one.

    Asked by: JL2JT

    Can a unit made for a jku be updated to work with the jt? Kept my unit from last Jeep thinking it may work and doesn’t!

    Asked by: Jaked
    • y_2020, m_8, d_2, h_15CST
    • bvseo_bulk, prod_bvqa, vn_bulk_3.0.10
    • cp_1, bvpage1
    • co_hasquestionsanswers, tq_13
    • loc_en_US, sid_3571-JT, prod, sort_[SortEntry(order=LAST_APPROVED_ANSWER_SUBMISSION_TIME, direction=DESCENDING)]
    • clientName_superchips
    • bvseo_sdk, p_sdk, 3.2.1
    • CLOUD, getContent, 6.84ms
    • QUESTIONS, PRODUCT